AEGIS SGR Installation and Selection

Selecting the Right Size SGR For Your Motor

• Step 1: Measure Shaft diameter at a point 1/8" (3mm) from motor end bell.
   
• Step 2: To select the correct SGR part number, refer to SGR size chart provided.
  • Part Numbers for NEMA Motors
  • Part Numbers for Metric Motors
  
   

Installation

For proper operation and optimum performance, install AEGIS SGR™ so that:

• The conductive MicroFibers. touch the shaft for effective shaft grounding.
   
• The aluminum brush holder frame extends out from the motor end bell approximately 0.28" (7mm).
   
• The aluminum brush holder frame has even clearance around the shaft.

1. Slide SGR over motor shaft and position for even clearance around the shaft.
    
2. Drill two 1/4" deep holes into motor end bell and tap each with a 6-32 thread or M# thread.
    
3. Lock SGR in place by fastening brackets to motor end bell using screws provided.